Once I knew where the clear panel would go, I needed to secure it. I did that by adding some more walnut trim and fancy brass screws.
Thursday, April 23, 2020
Coin Drop Back Board
The coin drop back board, at this point, is just a board. It needed the clear front panel added to it and I needed to figure out how that was going to happen. Most importantly I needed to determine how far off the push platform the bottom edge of the clear panel would be. So I stacked up some blocks, taped things in place, and began testing different heights by dropping coins.
Once I knew where the clear panel would go, I needed to secure it. I did that by adding some more walnut trim and fancy brass screws.
Once I knew where the clear panel would go, I needed to secure it. I did that by adding some more walnut trim and fancy brass screws.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment